www.haivision.com
Makito X4 Encoder 1.1
Makito X4 Rugged Encoder Installation Guide
12
Generated on: 2024-02-08 22:26:05
HVS-ID-IG-MX4ER-11, Issue 01
1.
2.
Powering up the X4 Rugged Encoder
There is no power switch on the encoder. The power is automatically on when the unit is plugged in.
To power up the encoder:
Insert the 4-pin connector of the
power cable
into the power input jack (
DC IN
) at the rear of the
encoder. Both power cables are shipped as part of the Evaluation Kit (#S-MX4E-R-SDI4-ISR-DK).
Make sure the connector is properly inserted and locked to avoid intermittent power problems.
Connect the power cable to a 28V power source. (The AC PSU can be used to convert from 120V
AC to +24V DC.)
Warning
When using the AC/DC power adapter, the power cord is the main disconnect device. Ensure that
the socket-outlet is located/installed near the equipment and is easily accessible.
ATTENTION
Quand on utilise l'adaptateur AC à DC, le cordon d'alimentation est utilisé comme
interrupteur général. La prise de courant doit être située ou installée à proximité de l'équipement et
être facile d'accès.