www.haivision.com
Makito X4 Encoder 1.1
Makito X4 Rugged Encoder Installation Guide
11
Generated on: 2024-02-08 22:26:05
HVS-ID-IG-MX4ER-11, Issue 01
3.
4.
5.
6.
(Optional) To configure d
ual NICs for either streaming or management purposes, c
onnect the
encoder's
Network 2
connector to the IP network.
Connect one or more of the encoder's
Video
connectors to your video source(s), referring to the
above image (front panel, Video Input). The BNC connector(s) are used for SD-SDI (Serial Digital
Interface), HD-SDI video, and Composite (CVBS) input signals. It is also a 3G-SDI capable interface
supporting 1080p 50/60 fps video @ 3Gbps.
(Optional) If you have a KLV or CoT source that uses RS-232 or RS-422, connect the encoder’s
Audio/Serial
connector to the metadata source or to the serial port of a computer using the audio/
serial breakout cable.
The Serial connector is used to ingest KLV/CoT, as a management port or as pass-thru for camera
control.
(Optional) To capture analog audio, connect the encoder’s
Audio/Serial
connector to your audio
source(s) using the the audio/serial breakout cable, shown in the previous step.
Note
The CVBS connectors are used to support legacy Analog NTSC/PAL/PAL-M cameras.
•
•
Note
The Reset button provides two options:
If you press and hold the button for less than 4 seconds, the system resets and loads the
last saved "startup" configuration. If no configuration was previously saved as the startup
preset, the default settings prevail.
If you press and hold the button for more than 4 seconds, the module performs a
complete factory reset. It clears all of the previously configured settings, including IP,
streams and encoder configurations.