Getting Started with the Web Interface
Accessing the Encoder
Makito X User’s Guide, v2.0, Issue 01
71
Default Encoder IP Address
NOTE
If you haven't changed the factory presets, and if not specified elsewhere in the
shipment, the encoder’s IP Address is set by default to:
10.5.1.2
.
To be able to log in to the Makito X Web interface, your computer has to be in the same IP
Address range (subnet).
You may have to temporarily change your computer’s IP Address to be in the same subnet
as the encoder. Only then you will be able to access the encoder and change the encoder's
IP Address, and then afterwards change your computer's IP Address back.
TIP
After you change the encoder IP Address, be sure to document it somewhere or label
the chassis.
Role-based Authorization
The Makito X uses role-based authorization control to secure the Web interface and CLI.
Administrators can create new accounts and thus allocate an account to each user of the
system.
The Makito X provides three defined account roles to assign privileges to users:
All three roles provide both Web interface and CLI access to the system. These roles and
their privileges are also supported using VACM (View-based Access Control Model) for
SNMP access control.
Administrators can create, delete, lock, and unlock user accounts, including changing the
password, from the Accounts page (see
Role
Default
Username
Default
Password
Privileges
Guest
user
public
Read-only access to the system.
Operator
operator
supervisor
All rights to configure A/V and stream
settings.
Does
not
include rights to reboot or
upgrade the system, modify the
network settings, or manage
accounts.
Administrator admin
manager
All access rights and Administrator
privileges.