Haivision Makito X, Руководство пользователя, Страница: 48 / 404

Installing the Encoder
Connecting the Encoder to the Network and a Computer
Makito X User’s Guide, v2.0, Issue 01 48
NOTE
The COM1 Port is DTE (Data Terminal Equipment) which defines the direction of
the signals (IN/OUT).
Serial Management Adapter DB9 Pinout (Makito X SDI only)
An adapter is required to interface with the serial port. A (gray) DB9 to RJ45 Serial
Management adapter (shown in Figure 2-3 on page 46) is included in the package.
The Serial Management adapter has the following pinouts:
7
Not connected Not connected
8
Not connected Not connected
Management Port
(RJ-45 Jack) Serial Port
(DSub-9 Female Connector)
Pin # Signal Pin # Signal
1
RI (Ring Indicator) - - - - - - - N/C
9
RI (Ring Indicator)
2
DCD (Data Carrier Detect( - - - - - - - - - - - - -
4
DTR (Data Terminal Ready)
3
DTR (Data Terminal Ready) - - - - - - - - - - - - -
6
DSR (Data Set Ready)
4
GND (Ground) - - - - - - - - - - - - -
5
GND (Ground)
5
RXD (Receive Data) - - - - - - - - - - - - -
3
TXD (Transmit Data)
6
TXD (Transmit Data) - - - - - - - - - - - - -
2
RXD (Receive Data)
7
CTS (Clear to Send) - - - - - - - - - - - - -
7
RTS (Request to Send)
8
RTS (Request to Send) - - - - - - - - - - - - -
8
CTS (Clear to Send)
1
DCD (Data Carrier Detect)
Table 2-1 COM1 Serial Port RJ45 Pinout (Cont.)
Pin # Signal RS-232 Signal RS-422