MANDO G211
Safety
Order h49 7144.907-333
11
2 Safety
This section provides an overview of all the important safety
aspects for optimum protection of personnel, and for safe
and problem-free operation.
2.1 Responsibility of the operator
The product is used in the industrial sector. The operator of
the product is therefore governed by the provisions of Health
& Safety at Work legislation.
As well as the safety notices in this manual, the area of use
of the product must also comply with locally applicable
safety, accident prevention and environmental protection
specifications as well as those in the manual for the machine
tool.
No modifications must be made to the product. The operator
is wholly and solely responsible for any resultant personal
injury and/or damage to materials.
Excepted from this are changing parts that HAINBUCH ap-
proved explicitly for autonomous machining, but specified
limits must never be exceeded.
DANGER
Serious injuries caused by parts being ejected
centrifugally due to a drop in actuating force / sup-
ply pressure!
On the machine, ensure that the actuating force /
the supply pressure do not drop while the product
is in use.
If no precautions have been taken on the machine
to maintain the actuating force / the supply pres-
sure, it is prohibited to use this product on the ma-
chine.
Pay attention to the operating instructions for the
machine tool.
In particular, note that end-stop requests by the machine tool
must be set on the product involved.
DANGER
Serious injuries caused by parts being ejected
centrifugally after defective setting of the ma-
chine!
Set up the end-stop requests by the machine tool
on the product involved.
On a regular basis, check the end-stop requests
of the machine tool [see »Maintenance schedule«
chapter].
If the limit stops are not reached, the product must
not be used any more.
