B-Top
Technical data
22
Order h49 7144.907-333
3.3 Balancing quality
The product is balanced before leaving the factory [balanc-
ing quality - see »General information« chapter].
DANGER
Serious injuries caused by parts being ejected
centrifugally if products are not balanced cor-
rectly!
Do not clamp rotationally symmetrical work-
pieces, or do so only after contacting the manu-
facturer.
Never remove balancing screws and weights at-
tached to the product.
NOTE
Material damage caused by machining with incor-
rectly balanced products!
Do not clamp rotationally symmetrical work-
pieces, or do so only after contacting the manu-
facturer.
Never remove balancing screws and weights at-
tached to the product.
3.4 Speed
The product is authorized for rotational operation.
The maximum speed is written on the product [maximum
speed, see »General information« chapter].
DANGER
Serious injuries caused by parts being ejected
centrifugally due to a non-compliant combination
of several products!
From all of the maximum speeds indicated for the
combined products, always remain at the lowest
of those maximum speeds.
DANGER
Serious injuries caused by workpieces being
ejected centrifugally after a loss of clamping
power!
If necessary, adjust the machining forces.
The maximum speed for specific machining must be defined
by the user on the basis of the clamping forces required. This
speed must not exceed the maximum speed of the clamping
device.
With unhardened top jaws or special jaws, ensure that the
chucks weigh as little as possible.
