– 41 –
Pressure Sensor
The pressure sensor’s purpose is to sense the
level of water in the tub when a cycle is being
run, or if the washer is sitting idle. The sensor
receives DC voltage and outputs that voltage
back to the control board.
The pressure sensor cannot be replaced by itself
if it malfunctions or is damaged. The complete
control board will need to be replaced, as the
sensor is mounted directly to it.
900/905 and 700/705 Model
600/605 Model
1
Pressure Sensor Diagnosing
The pressure sensor uses a digital protocol (I2C)
instead of an analog signal. Therefore, the DC
output voltage cannot be measured.
To verify the pressure sensor is operating
properly, enter Service Mode and follow the
test description for Test 10: Flow Rate/Pressure
Sensor.
