– 37 –
The bleach funnel directs the liquid bleach to the
top cover, dispensing it between the outer tub
and the basket. There is no water valve to rinse
the funnel after use.
Bleach Funnel Removal
1. To remove the bleach funnel, reach between
the top cover and tub cover and push up on
the bottom of the funnel.
2. Push the undercut ribs tilt the funnel up to
release locating tabs and remove.
To install the funnel onto the top cover, the
locating tab needs to slide into the opening first.
Then push down on the funnel to seat into
position (for 900/905 models only).
The bulk tank is used to store 50 Oz., of
detergent, which will dispense automatically
based on the load to the basket with the help of
the dosing pump. It is located at the bottom of
the top cover.
Bulk Tank Removal
1. Remove backsplash assembly and main
board (see the
Cabinet and Structure
section of this guide). Remove the top cover
assembly (see the
Capacitor (For 600/605
Models Only)
section of this service guide).
2. Remove the dosing pump (see
Dosing Pump
Removal
under
Dosing Pump (For 900/905
Models Only)
in this section of the service
guide). Remove the bulk tank level sensor
(see
Bulk Tank Level Sensor Removal
under
Bulk Tank Level Sensor
in this section
of the service guide).
3. Remove two hex-head screws, then reach
under top cover and push the bulk tank to
disengage the snaps from top cover and then
remove it.
Bulk Tank (For 900/905 Models Only)
Bleach Funnel
Bleach Funnel
Screws
Bulk Tank
Bleach Funnel
Screws
