– 44 –
J801
6. Located inside the tub is a self-cleaning
screen filter. To access this filter if it needs
to be replaced, remove the hose clamp
securing the water tube to the nozzle in
overnight hose. This is what cleans the filter
in the tub.
7. Then remove the clamp that secures the
overnight hose to the tub.
8. Lift the hose away from the tub to expose the
filter screen.
9.
Remove the filter from the tub and clean or
replace as needed. This is a self-cleaning
filter and should not need to be serviced.
Tub Light
The tub light is an LED light used to illuminate the
basket to make viewing easier for the consumer.
It is mounted into the door gasket. The tub light
will turn on when the door is opened or if turned
on from the control panel. The LED will turn off
after five minutes. If the light is already on and
the door is opened; the 5-minute timer will restart.
When the door is closed, the light will turn off.
LED Diagnosing
The LED tub light is a diode that lights up. It
operates on approximately 3.3 VDC. This is
checked from the J801 connector on the main
board. If voltage is present but the LED does not
light up, verify the light is good.
1. Disconnect the J801 from the main board or
disconnect the in-line connector to the LED.
2. Set the meter to Diode setting.
3. With the black lead of the meter on the
red
wire of the LED, and the red lead of the meter
on the
black
wire of the LED, the meter
should read approximately 0.727, if good.
If the red lead of the meter is on the
red
wire and
the black lead on the
black
wire, there should be
no reading.
There is also an inline connector for the tub light.
The complete main harness does not need to be
replaced unless the harness is found to be the
fault.
Tub Light Removal
1. Remove the control panel and front panel
(see
Control Panel
and
Front Panel
in this
section of the guide).
(
Continued next page
)