– 32 –
Front Control Console Removal
1. Remove the door and separate the inner and
outer door panels.
2. Remove the vent cover from the inner door.
3. Push down on the pocket handle, then lift up
and away from the console on the tabs to
release the console from the pocket handle.
4. Tilt the bottom upward. When both sides are
released, rotate the console to release the
tabs at the top of the console.
All other models have a power vent assembly
to aid drying. The vent assembly mounts to the
Inner Door as shown below. Please see the vent
(
Inner Door Vent Cover
,
Vent Parts
,
Venting/
Airflow
) and power dry (
Power Dry System
Removal
,
Power Dry Forced Air
) sections of
this guide for details.
To Reassemble the Door:
1. Place the outer panel face down on a
protected surface.
2. Place the inner door face up, and position six
attachment tabs into the cutouts of the outer
panel.
3.
Press firmly together while sliding the inner
panel onto the outer panel. Use care to make
sure that the outer panel mates properly to
the front console or top console. The below
illustration has a portion of the door sectioned
or cut out to show the outer door panel
engaged with the attach tabs of the inner door.
4. Reinstall screws and reinstall the door.
Outer door has cutouts to receive inner door tabs
Models GDF565 and GDT565 have a passive
vent as shown below. The front control console
is held in place by four tabs on the pocket handle.
Pocket Handle
Locking Tabs
Front Control Console
