Haier FlexFit Pro AL24LP2VHA, Руководство по обслуживанию

Страница: 74 / 121

70
FlexFit Pro
4. Error Code
4.1 Failure code indoor unit
AL24LP2VHA AL36LP2VHA AL48LP2VHA
LED flash times of
indoor PCB
LR.Recever
digital display
Contents of malfunction Possible reasons
LED4 LED1
0 1 01
Malfunction of indoor unit ambient
temperature sensor
Sensor disconnected, broken, shorted,
or at wrong position.
0 2 02
Malfunction of indoor unit piping
temperature sensor
Sensor disconnected, broken, shorted,
or at wrong position.
0 4 04 PCB EEPROM error
EEPROM chip disconnected, broken,
or programmed incorrectly.
PCB defective.
0 7 07
Abnormal communication between
indoor and outdoor units
Poor wiring connections, faulty wiring,
poor power supply, incorrect addressing
of indoor units, malfunction of slave unit
programming in MAXI system; faulty
PCB.
0 8 08
Abnormal communication between
wired controller (or IR reciever) and
indoor unit
Wrong connection or wired controller
broken, or PCB faulty
0 12 0C Malfunction of drain system
Condensate pump disconnected
or faulty, float switch a wrong
position, disconnected or faulty, or a
disconnection of the short circuit bridge
0 13 0D Zero cross sigal wrong Zero cross signal not detected
0 14 0E Indoor unit DC fan motor abnormal
Fan motor disconnected, faulty wiring,
motor failure, or faulty circuit to motor
Note:
1. The outdoor failure can also be indicated by the indoor unit, the checking method as follows: If the outdoorerror
code is M (DECIMAL) , the indoor unit's I.R. receiver display will show the after converted hexadecimal code of
"M+20" (DECIMAL) , for example, if the outdoor error code is 2, the indoor unit I.R. receiver display will flash the
error code 16 (2→2+20=22→change deciaml 22 to hexadecimal code, get 16)
2. LED4 is a red one on the indoor PCB, LED1 is a yellow one.
3. To get much more details about the out door unit failure, please refer to the outdoor unit trouble shooting list.