Installation Method
z
Prior to installation of the water heater, firstly ensure
the back wiring installation of water heater is secure.
Pre-install a safety valve and flow sensor as well as
one elbow thereof, then dismantle the bottom cover,
install the elbow equipped with safety valve and the
other elbow on the inlet & outlet pipes, respectively
(the handle of the safety valve is installed at one side
near the outlet pipe, as shown in Fig. 2), and insert the
terminal of the flow sensor into the socket of the flow
sensor. After the installation is finished, tighten the
drain pipe of the safety valve, and use sealing tape to
prevent leakage. Please increase the washer to the
articulated joint of the elbow during the installation of
the elbow.
z
After the above installation is completed, determine
the installation position of the water heater. According
to dimensions shown in Fig. 1, use an electric drill to
drill four
Φ
12mm holes with 65mm depth in the wall,
insert the expansion hooks and expansion bolts into the
corresponding wall holes, secure the hooks and bolts,
raise the water heater, put the wall-mounted bracket on
the hooks and bolts, install the flat washers, back
wiring of water heater, and nuts onto the bolts in the
proper order (as shown in Fig. 3), and tighten the nut
and check if it is secured.
z
In order to facilitate the installation and dismantlement
of water heater, it is suggested to additionally install
G1/2” movable nuts at the proper position of the inlet
& outlet pipes of the water heater, respectively.
Determine the position of water supply, and connect
the inlet & outlet water pipes and tap water pipe with
water consumption point, respectively. (Refer to Fig.
4) Fill the interior shell with water and check if the
water circuit leaks. It must be repaired if there is any
leakage. Place the signal wire into the decoration cover
of shockproof wall if there is no leakage, and re-install
the bottom cover.
z
Note: Remove your hands until it is certain that the
wall-mounted bracket is mounted securely on the hook
to prevent the falling of the water heater, which may
result in bodily injury or property damage.
7
Front of the
Water Heater
Back of the
Water Heater
Fig. 3
Fig. 2
Fig. 4
Inlet of Cold Water
Mixing Valve
Sprayer
Outle
t of
Ho
t W
ate
r