Hague Quality Water WATERMAX H2000, Руководство по установке владельца

Страница: 19 / 48

Installation Steps and Start-Up Procedures, Cont.
Step 3
Install the Spigot Assembly
The most convenient installation would allow the use of an existing spray attachment hole. If the
spray attachment hole is not available, then follow the basic procedures outlined below.
Drilling a stainless steel sink:
A.
Mark the sink location for the center of the faucet.
B.
Impact punch the sink top to provide a starting point
for the drill bit.
C.
Drill a 1/4-inch pilot hole in the sink using a
high-speed drill bit.
D.
Drill a 1/2-inch diameter hole to accept the bolt of a 1-
1/4-inch Greenlee Chassis Punch.
E.
Set the punch and turn the nut with a wrench to cut
the hole. Follow Greenlee instructions.
Drilling a porcelain clad steel or cast iron sink:
A.
Mark the sink location for the center of the faucet. Be
sure the location you select is not over a reinforcing
rib. Check the location from below.
B.
Grind away a 1-1/4-inch diameter circle in the
porcelain using a silicon/carbide wheel and high-
speed grinder (See
Installation Tool List
), down to the
metal surface of the sink. (See Figure 7)
C.
Impact punch a small indent in the center of the area
ground away.
D.
Drill a 1/4-inch pilot hole through the metal base
using a standard high-speed drill bit.
Caution:
Be careful when the drill is about to penetrate
the base metal of the sink. Reduce the speed and
support the drill so the drill chuck does not impact the
porcelain or enamel.
Figure 6: Air Gap Spigot Assembly
E.
Use the pilot hole as a guide to drill a minimum 1-inch up
to a 1-1/4-inch diameter hole with carbide bits to mount
the RO air gap spigot.
Figure 7: Grinding Wheel
WaterMax RO Owner’s Manual 11/11/2009 19