Hagie NTB Series, Руководство пользователя, Страница: 15 / 52

3-1
5 - DASH / AUT
O
SECTION 3 – OPERATING YOUR NTB
MACHINE DISPLAY WARNING
MESSAGES - 60’ NTB
When operating machine functions, such as
Tread Adjustment, All-Wheel Steer (AWS), and
Float operation, various warning and
confirmation messages will appear on your
Machine Display to avoid property damage.
NOTE: These warning and confirmation
messages will reset and the operator
must acknowledge these messages again
any time the NTB is installed and the Left
or Right Boom Switches (located on the
Hydrostatic Drive Control Handle) are
pressed in the “Fold-In” position, the
machine’s drive state is changed from
Road to Field Mode, the AWS or Float
Buttons (located on the Machine
Display) are pressed, or each time the
ignition key is cycled.
Tread Width Adjustment
-If Equipped
When any of the Tread Width Adjustment
Buttons (located on the Machine Display
Auxiliary Controls Page) are pressed, a warning
message will appear stating that before Tread
Width Adjustment will be enabled, ensure the
NTB is in the UNFOLDED position.
•
Press ACKNOWLEDGE to accept.
After the first warning message has been
acknowledged, a second confirmation message
will appear, which is an assurance confirming
that the NTB is unfolded and you want to
proceed.
•
Press ACKNOWLEDGE to accept.
NOTE: If you run the wheels into the bar after
you have pressed “Acknowledge” on the
confirmation message, the warranty will
be voided.
Refer to your machine operator’s manual for
further information on Tread Width Adjustment.
All-Wheel Steer (AWS)
-If Equipped
When the AWS Button (located on the
Machine Display Home Page - Field Mode) is
pressed, a warning message will appear stating
that before AWS will be enabled, ensure the NTB
is in the UNFOLDED position.
•
Press ACKNOWLEDGE to accept.
Tread Width Adjustment
Warning Message
Tread Width Adjustment
Confirmation Message