Hagie 204SP, Руководство оператора, Страница: 100 / 127

SECTION 8 –
MAINTENANCE AND STORAGE
8-23
* Use proper equipment.
** 250-500 hours or yearly, whichever occurs first.
STORAGE
Preparing For Storage
1. Perform daily level checks, lubrication,
and bolt/linkage inspections, as required
in this manual.
2. Every other season, drain the coolant
from the engine and radiator. Probe the
drain holes during drainage to ensure
they are not clogged by sludge, scale, or
other deposits.
Fill the cooling system to the top with a
50/50 water/antifreeze mixture. Run the
engine to operating temperature and
recheck level.
3. Add a fuel stabilizer to the fuel and fill the
tank.
4. Run the engine until it reaches operating
temperature, then drain the engine oil.
Refill with fresh oil of recommended
weight and install a new lubricating oil fil-
ter element.
5. With the engine at normal operating tem-
perature, cycle all hydraulic functions,
including the steering.
6. Release tension on all belts.
7. Use plastic bags and water-resistant
adhesive tape to seal the air intake
opening, all exhaust manifold openings,
engine oil filter cap, hydraulic oil tank
breather cap, and fuel tank caps.
8. Turn the Battery Disconnect Switch OFF.
9. Disconnect and remove batteries. Com-
pletely clean and charge the batteries.
Coat the terminals with dielectric grease
Service Point Initial Daily/
Before
Each
Use
As
Required
50
Hrs.
100
Hrs.
250
Hrs. **
500
Hrs. **
1000
Hrs.
Clean Battery X
Change Engine Oil Filter X
Change Engine Oil X
Change Wheel Hub Oil X
Pack Bearing on Non-Drive
Quad Puller Tire Hub X
Change Charge Pressure
Filter X
Change Hydraulic Return
Filter X
Change Primary Fuel Filter
(Water Separator) X
Change Secondary Fuel
Filter X
Check Radiator Coolant
Concentration X
Change Hydraulic Reservoir
Oil X
Change Radiator Coolant X