19
Installation and Maintenance Manual, Compact CBP
Installation
3.1.4a Mounting the motor onto the driven shaft
The motor can be mounted onto the driven shaft with or without a mounting tool, but the use of a
mounting tool is recommended since it makes the work easier.
Mounting the motor with a mounting tool
(Fig. 3.10)
- Remove the End cover together with screws and washers.
- Align the motor with the driven shaft.
- Locate the existing plastic washer between the nut on the mounting tool and the bearingretainer.
Pass the mounting tool through the centre of the motor, and screw it into the driven shaft to stated
depth by using the key handle in the end of the tool.
- Pull the motor onto the shaft by turning the nut on the mounting tool.
- Remove the mounting tool.
- Refit the plug.
- Refit the end cover and tighten the screws together with washers. Torque 81 Nm (59 lbf·ft) for
CBP 140, and torque 15 Nm (91 lbf·ft) for CBP 80-840.
Fig. 3.10 Mounting the CBP
Plastic Washer
Mounting tool
Nut
