hager h3+, Инструкция по эксплуатации системы связи

Страница: 77 / 127

77
6LE005550A
Starting, commissioning, operation
4.2 Starting and configuring the circuit breaker
Here is the procedure to follow in order to connect the supply directly to the
CIP connector:
Action Note
1 Switch the Energy circuit
breaker to the OFF or
tripped position.
2
Open the front cover of the
circuit breaker. The front cover of the circuit breaker can only be opened in
the OFF or tripped position.
3 Insert the CIP connector
for the HTC140H adapter
in one of the connectors
marked CIP inside the
circuit breaker on the left-
hand side
- Risk of damaging the CIP connector.
- Respect the direction of insertion for the connector: The
adapter part marked CIP must be visible from the front.
- Avoid forcing the connector when inserting.
4 Route the cable for the
HTC140H adapter along
the left-hand side cable
channel of the circuit
breaker provided for this
purpose.
If necessary, use the side
support supplied with the
circuit breaker to connect
the cable to the side wall
(see illustration below).
it is advisable to provide a 24 V connection terminal near the
circuit breaker to connect the + and – wires for the HTC140H
adapter. The wiring of the 24 VDC circuit may be extended
from this terminal up to the 24 VDC supply terminals.
+ wire: Brown colour
- wire: White colour
Please respect the wiring rules in force in switchboards:
- Separate the routing of the power cables and the circulation
of low-level signal cables
- Secure the cable along the routing.
5 Close the front cover
of the circuit breaker to
immobilise the side support
as well as the side cable
routing.
Routing the HTC140H cable using the side support.
CIP cables and side support