For your safety
2
Technical changes reserved
1
For your safety
General safety information
-
Before commissioning, check the smoke alarm to ensure it is functioning
properly.
-
The operating/installation manual must be stored at the operating site of the
fire safety housing at all times.
-
Legally required safety notices must be displayed in a clearly visible location
for users.
-
All safety and danger notices, and the nameplate must be maintained in a
legible condition.
-
Observe the relevant provisions of the VDE (Association for Electrical,
Electronic & Information Technologies).
-
Observe the requirements of the fire authorities.
-
Observe the general building law and building regulations.
-
Observe accident prevention guidelines and workplace guidelines.
-
Observe the instructions of the technical supervisory service.
-
Ensure compliance with the relevant standards when evaluating fire
protection and structural engineering aspects.
-
Only use the products if they are in proper condition.
-
Make sure that the required safety checks are carried out by personnel
authorized by us.
-
Due to the heavy weight of the product, damage and defects caused by
improper transport and installation can only be reliably avoided by specialist
personnel trained and authorized by us.
-
The stability of the housing will be impaired if the doors are open when the
housing has not yet been screwed onto the structure.
-
Keep the opening range of the door free at all times.
-
Observe the technical specifications in our catalogue or data sheet for the
relevant product.
-
Take into account the total power loss of the installed devices and wiring in
comparison with the specified power loss of the housing. The specified
power loss estimations are ideal values; they assume average ambient values
such as temperature, humidity, mounting surface, uniform arrangement of the
switching elements, etc.
-
Please also note that, depending on the positioning of the installed elements,
"hot spots" can form. It is therefore important to ensure that the built-in
components are distributed as evenly as possible. If necessary, this should
be verified by means of a test measurement in the interior.
-
Unauthorised access to the housings is not permitted.
-
The doors of the housing must be kept closed when in operation.
-
Incorrect installation can impair the protection function.
-
Observe all of the instructions in this manual.
-
Only use approved and suitable screws/dowels to screw the housing onto the
structure.
-
Check the suitability of the screws/dowels for the specific structure.
-
The housing must not be glued, varnished or coated in any other way.
-
The body of the housing must not be damaged (holes, screws).
-
The locking systems may not be modified or replaced.
-
All screw heads must be fitted with cover caps.
Intended use
-
The products described in this operating/installation manual are
state-of-the-art and built in accordance with established safety regulations.
