Hafele E-drive Series, Руководство пользователя

Страница: 11 / 49

H
D
E
1
4
.1
2.
2012
11
OPERATING INSTRUCTIONS
en
3 General safety
instructions
The e-drive automatic drive has been built in accordance with the latest state of
technology and the recognised technical safety regulations. Nevertheless,
hazardous situations may still arise during operation that can lead to injuries or
damage to the product! The following safety instructions must be followed during
operation in order to avoid danger.
Basic safety instructions
> Never use automatic drive without securing it to the furniture item.
> Only install the automatic drive in approved suspended door cabinets with
suitable cabinet doors. Do not attach any additional objects.
> Do not hold onto the cabinet doors when they are being opened and closed.
> In the event of damage, smoke or the occurrence of unusual
noises/odours, disconnect the automatic drive from the power supply
immediately and contact the manufacturer.
> Do not carry the automatic drive using the power supply cable.
> Check all supplied product components for damage before installing! Never
install damaged product components but complain to the manufacturer.
> Do not omit any supplied parts. Keep to the installation order. Do not install
any parts that are not approved by the manufacturer.
Electrical safety
> Never immerse the power supply plug and the automatic drive in water,
expose to humidity, do not wet clean or touch with wet hands.
> Never replace or modify the power supply plug or the power supply cable.
> Do not place containers filled with liquid on the furniture item or the
automatic drive. They could tip over and water could penetrate into the
control unit. Risk of short circuit and fire!
> Do not jam, crush, bend or damage the cable during installation (e.g. by
drilling or cutting). Do not route cables over sharp edges or corners. Install
cables at a sufficient distance to movable or rotating parts.
> Carefully tie up excess cable (tension-free) using cable ties or strain reliefs.
The route of the cable must be clearly visible. Ensure that the cables cannot
become trapped or subjected to tension during operation.
> Do not route cables on the floor. They can be a dangerous tripping hazard
and can become damaged from being walked on. Route cables so that
children cannot become entangled up in them or even strangled.
> Never insert objects into the control unit or open the housing of the control
unit.
> Disconnect from power supply if you are going to be away for any length of
time.
> Never pull the power supply cable, but always pull the mains plug.
> An earthed shockproof socket installed according to national regulations
must be available for the electrical connection. The connecting data of the
socket must correspond with that of the automatic drive (see chapter “
14
Technical data” ).
> Do not connect the automatic drive directly to the socket until installation is
complete. The use of output extenders or adapters is prohibited!