H
D
E
3
0
.1
0.
2019
732.
22.
03
6
18
6.2 Operate with the Programming Key
7. Support
Sleep Mode
After three consecutive incorrect User Code entries to unlock, the lock will go into „Sleep
Mode“ for one minute and for an additional minute for each subsequent incorrect entry. The
keypad is disabled while in „Sleep Mode“. A registered Manager Key may be used to unlock
while lock is in „Sleep Mode“.
Error Condition Indicators
10 rapid beeps:
The lock is binding which means that either door alignment or items in the locker are
preventing the lock from operating. Press on the door while operating the lock. If error
condition persists, contact Hafele support for assistance.
2 sets of three beeps:
The batteries are low. Replace the batteries.
Does not Unlock with the User Code
The lock does not recognize the User Code. For immediate access, operate with a registered
Manager Key. Follow instructions to
5.4 Assign the User Code (assigned use only)
to assign
a new User Code to the lock.
Does not Operate with a Manager Key
The lock does not recognize the Manager Key. Follow instructions to
to register the Manager Key to the lock. For immediate access, operate with another registered
Manager Key or with the Programming Key.
Does not Operate with the Programming Key
The lock does not recognize the Programming Key. If the Programming Key has been
replaced, operate with the Replacement Programming Key. Contact Hafele support for
additional assistance.
To unlock:
Press
Ⓒ ⚿
then insert the Programming Key.
To relock:
Close the door.
ins-srce-732.22.036.book Seite 18 Dienstag, 29. Oktober 2019 1:26 13
