732.28.428
HDE 27.07.21
8/11
en
3. Standalone Mode
3.1. Standalone Mode – Wall Switch as Provisioner
To conigure a network without the App, you can use the Wall Switch as the provisioner (controller). By this you can
provision mesh boxes with monochrome, multi-white lights or RGB lights.
Attention: Only one wall switch can be used to control the network. In case more wall switches are required, please
use the Remote Control Standalone Mode or use the Connect Mesh App.
3.1.1. Wall Switch Standalone Mode with Monochrome Lights
To start, the wall switch needs to contain a irmware version of at least 4.4.6 (otherwise please update the Firmware)
and needs to be reset (status led blinks).
1. Start the search for mesh boxes by pressing the two upper buttons for 4 seconds. The led will start blinking
(slowly).
2.
Find and conigure Mesh Box: When the led starts to blink fast, a mesh device is found and will get conig
-
ured.
3. To stop searching for other mesh boxes, press any button of the switch. To start searching again, continue
with step 1.
The buttons of the switch will control the mesh box in the following way:
•
Upper left button: Controls port 1 and 4 (on/of, dimming)
•
Upper right button: Controls port 2 and 5 (on/of, dimming)
•
Lower left button: Controls port 3 and 6 (on/of, dimming)
•
Lower right button: Controls all ports (on/of, dimming)
Group 3
• ON/OFF:
Single Click
• Dim Up/Down:
Longpress
[image 7]
Group 1
• ON/OFF:
Single Click
• Dim Up/Down:
Longpress
Group 2
• ON/OFF:
Single Click
• Dim Up/Down:
Longpress
Group ALL
• ON/OFF:
Single Click
• Dim Up/Down:
Longpress
Constant Power
Group 3
Group 1
Group 2
Group 3
Group 1
Group 2
