732.28.428
HDE 27.07.21
6/11
en
2.2. Setup
Battery Compartment
(CR2430)
[Image 5]
Open the battery compartment on the backside of the wall switch and insert the button cell (CR2430). You may need
to press one of the four buttons irst to wake up the wall switch. Only then will you receive status information via the
status LED (see chapter 3.7 for more information).
2.3. Switching a group on/of
Connect Mesh Wall Switch can be provisioned in the Connect Mesh App. After provisioning, you can start conigur
-
ing the four physical buttons within the Wall Switch's settings. Possible coniguration in Wall switch are "Toggle On/
Of", "Turn Group On", "Turn Group OFF", Scenes A,B,C or user-deined scene. We recommend to use "Turn Group
On" and "Turn Group OFF". For further details, please refer to Connect Mesh App Operational Manual.
2.4. Dimming
To dim the light, press and hold the button connected to the group. The brightness increases until you release the
switch or the maximum brightness is reached. Repeat the long press again to reduce the brightness in the same way.
2.5. Update Mode
In case the irmware is outdated, the user will be notiied in the Connect Mesh App. Then the user can start and per
-
form the irmware update of the Mesh device. (more information in the speciic
Häfele Connect Mesh App
).
Option 1: Update via App
If the Mesh device is provisioned and the update can be done by:
1.
Click on Mesh device and click on edit icon and scroll down to the bottom of the page. You can ind the
"Update Device icon".
2.
Click on this icon to update the Firmware.
Option 2: Manual Update
via Power On/Of (Version 1 only)
1. Insert the battery to start the device and the LED will start blinking.
2. Remove the battery and insert it again.
Repeat this 4 times of consistent intervals of 2 seconds each .
3.
The irst group LED will start blinking faster to signify the device in Update Mode and can be updated using
the Häfele Connect Mesh App.
4.
Press "Menu" icon, click on "Settings" and click on "Extended Settings" and then click on "Search device in
Update Modus". The mesh device will be displayed. Select Mesh device to start the Firmware Update.
Option 3: Manual Update via Reset Button (Version 2 only)
1. Press and hold the Reset Button on the Mesh device and at the same time, connect the Mesh Device into
Power supply. This will bring the Mesh device in OTA- Update mode.
2.
Press "Menu" icon, click on "Settings" and click on " Extended Settings" and then click on "Search device
in Update Modus".
3.
The Mesh device will be displayed. Select Mesh device to start the Firmware Update
.
