732.28.428
HDE 27.07.21
10/11
en
3.1.3. Wall Switch Standalone Mode with RGB Lights
To start, the wall switch needs to contain a irmware version of at least 4.4.6 (otherwise please update) and needs to
be reset (status led blinks).
1. Start the search for mesh boxes by pressing the upper left and lower right buttons for 4 seconds. The led
will start blinking (slowly).
2.
Find and conigure Mesh Box: When the led starts to blink fast, a mesh device is found and will get conig
-
ured.
3. To stop searching for other mesh boxes, press any button of the switch. To start searching again, continue
with step 1.
The buttons of the switch will control the mesh box in the following way:
•
Control RGB Light 1, connected to port 1, 2 and 3: Controlled by left upper and lower buttons
•
Control RGB Light 2, connected to port 4, 5 and 6: Controlled by right upper and lower buttons
Upper button:
•
Single tap: On/Of
•
Long press: Dim up/down
•
Tap and long press: Saturation up/down
Lower button:
•
Long press: Change Color
Group 2 (RGB)
• Col Up/Down:
Longpress
[image 9]
Group 1 (RGB)
• ON/OFF:
Single Click
• Dim Up/Down:
Longpress
• Sat Up/Down:
Double Click
Group 1 (RGB)
• ON/OFF:
Single Click
• Dim Up/Down:
Longpress
• Sat Up/Down:
Double Click
Group 2 (RGB)
• Col Up/Down:
Longpress
Constant Power
RGB Group 2
RGB Group 1
*double tap and hold with same behaviour
as dimming (one direction/other direction)
