Hafco BS-13DS, Руководство по эксплуатации и запасным частям

Страница: 18 / 40

The gearbox should be drained and refilled after the first 50 hours of
use and thereafter every 5 months, with Mobil Synthetic Gear Oil,
SHC-636, ISO Viscosity Grade 680. This oil meets or exceeds
American Gear Manufacturers Association (AG.M.A.) #8
compounded Cylinder Oil specifications. This oil is available
through Grainger's in 1 quart bottles as number SW061.
Fig.22 A
Fig.24 C A
To change the gear oil, proceed as follows:
1. Run the machine for 10 minutes to warm up the gearbox.
2. Disconnect the machine from the power source.
3. Raise the saw arm to its maximum position and close the feed
rate control knob.
4. Drain the gearbox by removing the screw away from the oil-out
hole (A) (fig. 22).
5. Replace a screw and lower the saw arm to its lowest position.
6. Open the oil-in hole and fill the gearbox with oil
7. Close the oil-in hole.
9-15.PIVOT
Occasionally lubricate the pivot using waterproof grease at the fitting
( C) (fig 23)
Fig.23 C
9-16. HOW TO OPERATE HYDRAULIC UNIT (FOR 330A)
1. This hydraulic unit is using (Esso,H15) oil. Change first oil
after 50 hours use. Then change oil every 6 months after.
Run the hydraulic unit for at least 10 minutes before
changing oil, this will let the oil flow smoother and easier
to change.
2. Open the oil outpour door with tool when changing the oil.
Let the used oil out completely. Close the outpour door
firmly, open the input door (A) and pour in the oil by 3 liter
(will be 80%full).
3. If in long time use, please watch out the oil temperature to
be 60º C maximum.
9-17. HOW TO USING CLEAN EQUIPMENT
After finished cutting, you can clean the chip by using clean
equipment.
Adjust the screw (A) (on the end of spray) to control the volume
of coolant fluid.
NOTICE : Please using the suitable volume of coolant fluid
for cleaning.
Cleaning the floor immediately when the coolant
fluid leaking on the floor.
Fig. 25 A
15