Hafco Woodmaster MJ2325D, Руководство пользователя

Страница: 12 / 33

18
Mounting the Micro-Adjustor to the Rip Fence
Mounting Bracket...
Locate the Micro-Adjustor and the Rip Fence. There are two fixing screws through the
adjustor mounting bracket with square nuts on them. Ensure the nuts are undone
sufficiently to allow them to slide into the channel in the Rip Fence mounting bracket
extrusion, position as required, normally slightly to the right of the rip fence, (See fig 17) and
tighten the screws securely. Locate the capping plates for the Rip Fence Mounting Bracket
and fit carefully using the self tapping screws. Fit the Rip Fence assembly to the saw by
ensuring the clamping lug at the rear of the fence is 'hooked over' the rear rail, lower the
fence and manoeuvre the bracket over the guide rail.
Fig 17
Micro-adjuster
Fitting the micro-adjuster to the rip
fence mounting bracket
Rip fence
Mounting bracket
Pls loosen eccentric wheel(as A shown) with the Inner Hex.spaner, then adjust the clearance
between the rack and the gear to make them engaged well .