Haemonetics ACP 215, Руководство по обслуживанию

Страница: 62 / 186

62 Preventive Maintenance and Installation
P/N: SM-ACP215-01-EN(AB) Haemonetics
®
ACP-215
®
Service Manual
Initial Inspection
Visual
Inspection
Inspect the following items to ensure that they appear to be in good working
order and do not have obvious scratches, dents, broken or missing hardware.
Note physical damage and missing or loose hardware on the service report.
Tighten and/or replace hardware as necessary. Scratched and/or dented
hardware need not be replaced unless the damage interferes with the
operation of the device.

Outside of cabinet

Screws for front and back panels (three in front and three in back)

Check that the fuses are the correct size for the region you are in
currently. (For 110V regions, 5 amp fuses are required. For 220V regions,
2.5 amp fuses are required.)

Cooling fans (mounted on rear panel)

Membrane panel

Pump rotors

Pump rotor screws (one in the center of each rotor)

Tubing guides

Centrifuge cover

Screws in the hinge of the centrifuge cover

Line sensor

Air detectors

System pressure monitor

Draw pressure monitor

Printer

Shaker
Ensure Initial
Operational
Integrity
Power on the device and ensure that it passes the initialization and safety
system tests before operating the device. This will assure you and the
customer that the device was operational before it was tested and alleviate any
doubt as to whether the service technician’s adjustments caused a problem
should the device fail to operate properly after the preventive maintenance is
complete.