HADEF 238/10, Инструкция по установке, эксплуатации и обслуживанию

Страница: 15 / 15

5.52.208.00.01.06
15
13.5 Lubricant for food industry – Selection (as option*)
SHELL MOBIL CASTROL
KLÜBER
Gearing
FM Grease HD2 Mobilgrease FM 222
--
Klüberoil 4UH 1-1500 N
Load chain
-- Lubricant FM 100
Optimol Viscoleb 1500 --
Load hook;
Pulleys
Gear rim;
Drive pinion
FM Grease HD2 Mobilgrease FM 222
--
--
* must be mentioned by order
14 Trouble
Please pay attention to the following in case of problems:

Troubles with the equipment must only be repaired by qualified personnel.

Secure the unit against unintended operation start.

Put up a warning note indicating that the unit is not to be used.

Secure the working area of moving parts of the unit.

Please read the chapter "Safety instructions".
Notes on the repair of faults are found in the following table.
For the repair of failures please contact our service department.
CAUTION!
Trouble caused by wear or damage to parts such as wire ropes, chains, chain wheels, axes, bearings,
brake parts, etc., must be remedied by replacing the parts with original spare parts.
15 Remedy
Trouble Cause Remedy
It is difficult to turn the crank if unloaded
not lubricated
worm gear is dirty
wrong installation
lubricate the worm gear and the worm gear shaft,
clean and lubricate again
straighten supporting surfaces and install correctly, if
necessary
load is not lifted, resp. held
rope is not winded correctly - rope turning direction for
lifting is not correct
place the wire rope correctly
brake is worn or defective check brake parts and replace parts that are worn
brake discs are humid or oiled clean brake discs or replace them by new ones
load pressure brake does not open.
brake mechanism or brake disc is stuck, possibly due to
seldom use
loosen the brake by slightly pushing the winch handle by
hand (in direction lowering)
replace the brake discs if necessary
16 Decommissioning
WARNING!
It is essential that the following points are observed in order to prevent damage to the equipment or critical
injury when the device is being decommissioned:
It is mandatory that all steps for decommissioning the machine are carried out in the indicated sequence:

First secure the working area for decommissioning, leaving plenty of space.

Read the chapter "Safety instructions".

Disassembly is carried out in reverse order to the assembly.

Please make sure that all operating material is disposed of in accordance with environmental regulations.
16.1 Temporary decommissioning

Measures are as above.

Also read the chapter “Transport and storage”.
16.2 Final decommissioning/disposal

Measures are as above.

After disassembly, ensure that the disposal of the equipment and any materials it contains is carried out
in accordance with environmental regulations.