5.52.624.00.01.01
5
The equipment is to be used exclusively for movement of goods. Under no circumstances persons may
be moved.
Never load the devices beyond their working load limit.
Observe the relevant national accident prevention regulations.
Building walls, ceilings, floors or constructions - on which the units are mounted or suspended - must be
checked by a structural engineer for sufficient stability.
After the unit has been standing for a longer period of time, visually inspect all components that are
important for its function and replace damaged components with new original spare parts.
Do not use a defective device.
Stop working immediately in case of disturbances and remedy failures.
Any damage and faults must be reported to a responsible supervisor immediately.
If the unit is put into operation, any persons in the immediate vicinity must be informed by calling to them!
Observe the provisions for load suspension equipment in accordance with the relevant national
regulations for the positive and non-positive slinging of loads.
The lifting tackle or the load must be securely attached to the device.
3
Transport and Storage
3.1
Transport
The goods are checked and adequately packed before delivery.
Do not throw or drop the accessories
Use adequate means of transport
Transport and means of transport must be suitable for the local conditions.
3.2
Storage
Store the accessories at a clean and dry place
Protect the accessories against dirt, humidity, corrosion and damage by an appropriate cover
4
Description
4.1
Areas of application
The devices must be as far as possible installed in a covered room.
If they are used in the open, protect the units against the effects of weather such as rain, hail, snow, direct
sunshine, dust, etc. - we recommend to use a cover in parking position. If the device is set up in a
continuously humid environment with strong temperature fluctuations, the correct functionings are
endangered by the forming of condensation.
NOTICE!
Use only in the intended atmosphere with a humidity of up to 100%, but not under water!
DANGER!
In particular, use is not permitted:
for tearing loose fixed loads, dragging of loads as well as diagonal pulling
for pulling against a fixed point without additional safety and/or measuring equipment against exceeding
the nominal load
in potentially explosive atmospheres, unless the equipment has been modified for this purpose and
this is shown on special type plates it carries for this purpose.
in reactor containments
for transporting persons
for holding lifted loads
for scenic use
when persons are under suspended loads
