Installation/ Cleaning und Maintenance/ Disposal
page 33 of 36
QSL-T/QST-150-25/45 V2
Standard
Original operating manual
Rev1.2
4.4
Connection of sensor cable
Assignment of sensor connector
Plug:
Molex Nano-Fit 105314-1210
For the connection to your converter of the HST-Series, we offer suitable adapter cables.
Please contact our sales department (see 8.3 contact information).
HINT
It must be ensured that the speed controller is connected to the temperature sensor of the
motor and reliably protects it from overtemperature.
5. Cleaning and maintenance
WARNING
Before cleaning or maintenance work, the motor must be shut down and secured against
unintentional restart.
If necessary, the motor can be cleaned with compressed air or a dry cloth.
6. Disposal
This product is marked in accordance with the European Directive 2012/19/ EU on waste
electrical and electronic equipment and must note be disposed of with household waste. To
return your old device, please use the return and collection systems which are available to
you.
You can also return your old device after use to your specialist supplier.
Pin
Assignment
Pin
Assignment
1
GND
6
+5V
2
Hall_2
7
Hall_1
3
Hall_3
8
N.C.
4
N.C.
9
N.C.
5
Temp_Sensor
10
GND_Temp
HINT
Do not clean the motor with water or wet objects. This can permanently damage the motor.
