Network and communications
N O T I C E
Only qualified personnel should perform the tasks described in this section.
About network and communications setup
This section shows the setup for:
• Serial communications
• Ethernet network communication
• Wireless (Wi-Fi) communication
• Wireless security
Setup for serial communication
N O T I C E
RS232 communication and manifold support cannot be used together because they use the same serial port.
1.
On the Counter Navigation screen, push
NETWORK
.
2.
Select the Serial tab.
3.
Configure these options:
• Select FX or Modbus RTU.
• Set the ID for FX or Modbus.
• Set the Baud rate.
• Select RS232 or RS485.
• Activate Manifold Support as needed (RS485 only).
• Activate Auto Increment Port as needed
Setup for Ethernet communication
1.
On the Counter Navigation screen, push
NETWORK
.
2.
Select the Ethernet tab.
3.
Configure these options:
• Select FX or Modbus protocol.
• Enter the Modbus port number.
• Enter the Configuration port number.
• Enter the IP address or select DHCP to let the network assign the IP address.
• Enter the subnet mask address.
• Enter the gateway address.
Setup for wireless communication
1.
On the Counter Navigation screen, push
NETWORK
.
2.
Select the Wi-Fi Configuration tab.
3.
Configure these options:
• Enter the Network name.
• Select the data rate.
• Select the network type: Ad hoc or infrastructure.
• Enable auto fallback as needed.
English
17
Содержание MET ONE 3400 Series
