9
Tank wall mount kit, LZX414.00.71000 and LZX414.00.72000
Attach the SONATAX sc
1.
Slide the O-ring over the sensor cable.
1.
Slide the sensor cable through the short (bottom) jointed pipe and bolt the pipe flange
to the sensor using the cap screws (M5 x 12 mm) and the spring washers for M5 (see
).
2.
Slide a plug and a sealing plug over the cable and use them to seal the short (bottom)
jointed pipe at the joint (see
3.
Slide a plug and sealing plug over the cable to seal the long (top) jointed mount pipe
at the joint.
4.
Slide the sensor cable through the long (top) jointed mount pipe.
5.
Using the plug and sealing plug, seal the long (top) jointed mount pipe at the joint.
6.
Insert a plug and a sealing plug in the top of the mount pipe. If necessary, shorten the
pipe and then insert the plugs.
Figure 9 Attach the brackets to the mount pipe
1
Threaded bracket
3
Unthreaded bracket
2
Mount pipe
