Operating instructions 4123
Flexproof-Cutter
AF-61/8x30
Page
7
of
14
Edition: 01/0206
Subject to alterations
4.3
Continuing Flexproof cutting
The belt/tape end has already fingers cut in correct shape.
From last cutting operation, the mark B is visible. This mark is used as a reference for the following
measuring and cutting procedure according to 4.2 (see illustration 2).
4.4
Serial Flexproof cutting process
If series of belts/tapes are to be cut, the lengths can be marked prior to cutting operation as shown on
illustration 2.
Insert belt/tape in Flexproof-Cutter and align mark B on the edge K of the cutting pad.
Carry out the cutting operation (see 4.1) and repeat this operation for every following mark B1, B2.....
A
150 mm
5.9 in.
B
x
Illustration 1: Cutting start from a new coil
B
B
1
x
B
2
B
3
x x
Illustration 2: Continuing and serial cutting
INDICATION
In case of frequent cutting the same belt/tape length it may be helpful to design an
adjustable stop for length measuring without the need to mark the belt/tape.
4123INS.FAB-en0306ITA
