Operating instructions 3745
Flexproof-Cutter
AF-603
Page 6 of
20
Edition: 01/0512
Subject to alterations
3. Initial
start-up
For safe operation, place the Flexproof-Cutter AF-603 on a solid workbench or table.
Attach the cutting support with screws to the workbench/table when the tool is used in stationary
operation.
Connect compressed-air hose to nozzle (6) and secure with clip.
Use only dry, oiled or unoiled compressed air.
Open compressed air valve (7), die-cutting head (23) will rise in the upper position.
Set air pressure with control knob to 5 bar/
72.5 psi
at pressure gauge (1).
Check if cutting pad (17) is in place and secured with set screw (12) to prevent shifting.
Mount appropriate die-cutting head (23) according to the desired cutting pattern. See 5.2 "Exchange
of the die-cutting head".
Set indexing device (4) to the corresponding cutting head finger pitch 8 mm/
0.32 in.
or 10 mm/
0.4 in.
(20 mm/
0.8 in.
= 2 crank rotations on 10 mm/
0.4 in.
setting). Loosen knurled screw (3), press index
lever (2) against machine frame and slide it to the desired punching pitch setting, rotate crank (5) until
index lever (2) snaps in, then tighten knurled screw (3).
By pressing index lever (2) against machine frame and simultaneously turning crank (5)
counterclockwise, move punching carriage (18) completely to the right side. Release index lever (2)
and turn crank (5) clockwise until index lever (2) snaps in.
This is the starting position of the punching carriage.
Lift clamping bars (13) with clamping device switch (8).
Check to make sure that the surface of the cutting pad where the belts/tapes are to be cut is clean.
Check sharpness of the cutting blades.
Содержание AF-603
Страница 15: ...Operating instructions 3745 Flexproof Cutter AF 603 Page 15 of 20 Edition 01 0512 Subject to alterations ...
Страница 16: ...Operating instructions 3745 Flexproof Cutter AF 603 Page 16 of 20 Edition 01 0512 Subject to alterations ...
Страница 17: ...Operating instructions 3745 Flexproof Cutter AF 603 Page 17 of 20 Edition 01 0512 Subject to alterations ...
