16
[Sysname]ip address
ip-address
{
mask | mask-length
}
5.
Optional: Configure the description of the current VLAN. VLAN interface name is
used by default, for example,
Vlan-interface1 Interface.
[Sysname]description
text
6.
Optional: Bring up the VLAN interface. By default, a VLAN interface is in the up
state. In this case, the VLAN interface is up so long as one port in the VLAN is up and
goes down if all ports in the VLAN go down. An administratively shut down VLAN
interface however will be in the down state until you bring it up, regardless of how
the state of the ports in the VLAN changes.
[Sysname]undo shutdown
Configuring WLAN service
WLAN service configuration includes enabling WLAN service, WLAN global configuration,
country code, service template, AP, radio configuration, and interface configuration.
To configure WLAN service:
1.
Enter system view.
<Sysname>system-view
2.
Required: Enable WLAN service. By default, WLAN service is enabled. All WLAN
services are available only if WLAN service is enabled.
[Sysname]wlan enable
3.
Required: Specifies a country code. By default, the country code value is CN. The
country code determines characteristics such as the power level and total number
of channels.
[Sysname]wlan country-code
code
NOTE:
You must set the correct country code or area code before configuring an AP.
If you change the country code for an AP that has a radio card not supported by the new
country code, the corresponding WLAN-radio interface will have its configurations of the
service template, maximum power, and channels removed automatically. For more
information about country code and country, see
WLAN Service
in the
WLAN Command
Reference
in the
H3C WX series access controllers Command References
.
Configuring a service template
