18
Appendix LEDs and ports
LEDs
Table 3
LED description
Mark Status
Description
Orange
•
Steady on—The AP is starting up.
•
Flashing (1 Hz)—The Ethernet interface is down or no radio interface is
detected.
•
Flashing (2 Hz)—The AP is in blink mode. The AP that acts as a fit AP has
associated with the AC successfully.
Green
•
Steady on—The AP that acts as a fit AP has not associated with the AC
successfully. The LED remains in this status until the AP registers successfully on
the AC.
•
Flashing (1 Hz)—Clients exist on the 2.4G radio interface.
Blue
•
Steady on—The AP has started up but no client is connected to the AP. If the AP
acts as a fit AP, the LED status means that the AP has registered successfully on
the AC.
•
Flashing (1 Hz)—Clients exist on the 5G radio interface.
•
Flashing (2 Hz)—The AP is updating its software. This status is available only for
an AP that acts as a fit AP.
Alternatin
g green
and blue
Alternating green and blue (1 Hz)—Clients exist on the 2.4G and 5G radio
interfaces.
Steady off The AP is initiating.
NOTE:
For more information about the blink mode, see
H3C Access Controllers Configuration Guides.
Ports
The AP provides the following ports:
•
One console port
•
One 10/100/1000 Mbps copper Ethernet port
•
One power port
NOTE:
The AP also has a reset button and a security slot. The security slot is 7 × 3 mm (0.28 × 0.12 in) in size.
