H3C WA2620X-AGNP, Инструкция по настройке через веб-интерфейс, Страница: 224 / 447

211
h. Select the AP from the device list or manually add the AP (with the IP address 10.1.1.2).
NOTE:
The IP address of the added access device must be the same as the source IP address of the RADIUS
packets sent from the AP. By default, it is the IP address of the RADIUS packets' outbound interface.
i. Click OK .
Figure 205 Access device configuration page
2. Add a user for device management:
a. Click the User tab.
b. Select Access User View > Device Mgmt User from the navigation tree.
c. Click Add to enter the device management user configuration page, as shown in Figure 206 .
d. Enter the username hello@bbb .
e. Enter the password abc and confirm the password.
f. Select the service type Telnet .
g. Set the EXEC privilege level to 3. This value identifies the privilege level of the Telnet user after
login, which is 0 by default.
h. Specify 10.1.1.0 to 10.1.1.255 as the IP address range of the hosts to be managed.
NOTE:
The IP address range must contain the IP address of the access device.
i. Click OK .