10-27
TEMP LED
LED status
Error code
Description
Flashing red
Temperature
sensor ID
A severe temperature warning is present on the
component monitored by the sensor.
This warning might occur because the temperature of the
component has exceeded the upper threshold or dropped
below the lower threshold.
CAP LED
LED status
Error code
Description
Flashing amber
01
The system power consumption has exceeded the power cap value.
Component LEDs
An alarm is present if a component LED has one of the following behaviors:
•
Flashing amber (0.5 Hz)
—A predictive alarm has occurred.
•
Flashing amber (1 Hz)
—A general alarm has occurred.
•
Flashing red (1 Hz)
—A severe alarm has occurred.
Use
to identify the faulty item if a component LED has one of those behaviors. To obtain
records of component status changes, use the event log in HDM. For information about using the
event log, see HDM online help.
Table 10-7 LED, error code and faulty item matrix
LED
Error code
Faulty item
BRD
01 System
board
02
Processor mezzanine board
03
Front drive backplane
11
Rear drive backplane
CPU
(processor)
01 Processor
1
02 Processor
2
03 Processor
3
04 Processor
4
DIMM
A1 through A9,
AA, Ab, or AC
DIMM slots for processor 1:
•
A1 through A9
—DIMMs in slots A1 through A9
•
AA
—DIMM in slot A10
•
Ab
—DIMM in slot A11
•
AC
—DIMM in slot A12
b1 through b9,
bA, bb, or bC
DIMM slots for processor 2:
•
b1 through b9
—DIMMs in slots B1 through B9
•
bA
—DIMM in slot B10
•
bb
—DIMM in slot B11
•
bC
—DIMM in slot B12
C1 through C9,
CA, Cb, or CC
DIMM slots for processor 3:
•
C1 through C9
—DIMMs in slots A1 through A9
•
CA
—DIMM in slot A10
