H3C UniServer R4900 G3, Руководство пользователя

Страница: 111 / 299

102
{
To remove an SSD, press the button on the drive panel to release the locking lever, and then
hold the locking lever and pull the drive out of the slot.
{
To remove an HDD, press the button on the drive panel to release the locking lever. Pull the
drive 3 cm (1.18 in) out of the slot. Wait for a minimum of 30 seconds for the drive to stop
rotating, and then pull the drive out of the slot.
Figure 127 Removing a drive
4.
Install a new drive. For more information, see " Installing SAS/SATA drives ."
5.
Install the removed security bezel, if any. For more information, see " Installing the security
bezel ."
Verifying the replacement
Use one of the following methods to verify that the drive has been replaced correctly:
•
Verify the drive properties (including capacity) by using one of the following methods:
{
Log in to HDM. For more information, see HDM online help.
{
Access BIOS. For more information, see the storage controller user guide for the server.
{
Access the CLI or GUI of the server.
•
Observe the drive LEDs to verify that the drive is operating correctly. For more information
about drive LEDs, see "Drive LEDs."
Replacing an NVMe drive
The drives support hot insertion and managed hot removal.
To configure RAID settings after the drive is replaced, see the storage controller user guide for the
server.
Only one drive can be hot inserted at a time. To hot insert multiple NVMe drives, wait a minimum of
60 seconds for the previously installed NVMe drive to be identified before hot inserting another
NVMe drive.
Procedure
1.
Identify the NVMe drive to be removed and perform managed hot removal for the drive. For
more information about managed hot removal, see "Appendix D Managed hot removal of
NVMe drives."
2.
Remove the security bezel, if any. For more information, see " Replacing the security bezel ."
3.
Remove the drive:
a.
Press the button on the drive panel to release the locking lever, as shown by callout 1
in
Figure 128 .
b.
Hold the locking lever and pull the drive out of the slot, as shown by callout 2 in Figure 128 .