35
NOTE:
If the start IP address is different from the management interface IP used for login, the system
refreshes the page and opens the
Hosts
page by using the start IP address. At next login, you
must use the start IP address as the management IP address.
5.
Select hosts for the storage cluster.
Figure 40 Selecting hosts for the storage cluster
6.
Click the icon for a host.
7.
Configure the following settings:
{
NIC Template
—Select whether to apply physical interface settings of the host to other
hosts. For this feature to take effect, make sure the other hosts have active physical
interfaces of the same names as those on this host and the interface speeds are as required.
If a host cannot meet the requirements, you must configure physical interface settings for
the host manually.
{
IP Address
—Specify an IP address for the management, storage back-end, and storage
front-end networks. The start IP addresses specified in the UIS Setup Wizard are used for
the management node. For a non-management node, if you do not specify an IP address
manually, the system assigns an available IP next to the start IP with an increment of 1 to
the host. You do not need to specify an IP address for the service network.
Figure 41 Customizing configuration for a host