9
2.
Use a Phillips screwdriver to loosen the screw at the right side of the CF card protection cover,
and pull the CF card protection cover outward.
Skip this step if the MPU does not have a CF card protection cover.
3.
Push the eject button on the CF card slot all the way until the CF card in the slot ejects. Remove
the CF card from the slot, and put the removed CF card on an antistatic bag or into its original
package.
4.
Before inserting the CF card, make sure the CF card eject button is pushed to the end and does
not reset automatically. Push the new CF card all the way into the CF card slot until the eject
button resets.
5.
Push the CF card cover inward and use a Phillips screwdriver to fasten the screw on the CF
card protection cover.
Skip this step if the MPU does not have a CF card protection cover.
Figure 9 Replacing a CF card
Replacing a transceiver module
WARNING!
Do not stare into any open apertures of operating transceiver modules or optical fiber connectors.
The laser light emitted from these apertures might hurt your eyes.
CAUTION:
•
During the installation or removal process, be careful not to touch the golden plating on the
transceiver module.
•
In case of limited space, you can use the provided tweezers and other tools to remove a
transceiver module or optical fiber.
1
2
3
4
5
6
Содержание SR8800-F
Страница 49: ...6 debugging commands in H3C SR8800 F Routers Network Management and Monitoring Command Reference ...
Страница 126: ...6 Figure 4 E1 cable 1 HM96 RJ 45 ...
Страница 127: ...7 Figure 5 E1 cable 2 HM96 SMB ...
Страница 148: ...12 Figure 14 Example of a device label ...
