50
Step
Command
Remarks
2.
Enter LDAP server view.
ldap server
server-name
N/A
3.
Configure the IP address of
the LDAP server.
{
ip ip-address
|
ipv6
ipv6-address
} [
port
port-number
] [
vpn-instance
vpn-instance-name
]
By default, an LDAP server does
not have an IP address.
You can configure either an IPv4
address or an IPv6 address for an
LDAP server. The most recent
configuration takes effect.
Specifying the LDAP version
Specify the LDAP version on the NAS. The device supports LDAPv2 and LDAPv3. The LDAP
version specified on the device must be consistent with the version specified on the LDAP server.
To specify the LDAP version:
Step Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Enter LDAP server view.
ldap server
server-name
N/A
3.
Specify the LDAP version.
protocol-version
{
v2
|
v3
}
By default, LDAPv3 is used.
A Microsoft LDAP server supports
only LDAPv3.
Setting the LDAP server timeout period
If the device sends a bind or search request to an LDAP server without receiving the server's
response within the server timeout period, the authentication or authorization request times out.
Then, the device tries the backup authentication or authorization method. If no backup method is
configured in the ISP domain, the device considers the authentication or authorization attempt a
failure.
To set the LDAP server timeout period:
Step Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Enter LDAP server view.
ldap server
server-name
N/A
3.
Set the LDAP server
timeout period.
server-timeout
time-interval
By default, the LDAP server timeout
period is 10 seconds.
Configuring administrator attributes
To configure the administrator DN and password for binding with the LDAP server during LDAP
authentication:
Step Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Enter LDAP server view.
ldap server
server-name
N/A
