162
Traffic mirroring configuration commands
mirror-to
Use
mirror-to
to configure traffic mirroring for a traffic behavior.
Use
undo mirror-to
to remove traffic mirroring configuration.
Syntax
mirror-to
{
cpu
|
interface
interface-type
interface-number
}
undo mirror-to
{
cpu
|
interface
interface-type
interface-number
}
Default
Traffic mirroring is not configured for a traffic behavior.
Views
Traffic behavior view
Default command level
2: System level
Parameters
cpu
: Mirrors traffic to the CPU, which is the CPU of the card where interfaces with traffic mirroring
configured resides.
interface
interface-type interface-number
: Mirrors traffic to an interface specified by its type and number.
Usage guidelines
The device only supports mirroring traffic to one destination interface. In a same traffic behavior, the new
configuration overwrites the previous one.
Mirroring outgoing traffic to interfaces only supports known unicasts, and does not support broadcasts,
multicasts, or unknown unicasts.
This command is supported only when SAP interface modules are operating in
bridge
mode.
Examples
# Create traffic behavior 1, and configure the action of mirroring traffic to the CPU for the traffic behavior.
<Sysname> system-view
[Sysname] traffic behavior 1
[Sysname-behavior-1] mirror-to cpu
# Create traffic behavior 1, and configure the action of mirroring traffic to port GigabitEthernet 2/0/1
for the traffic behavior.
<Sysname> system-view
[Sysname] traffic behavior 1
[Sysname-behavior-1] mirror-to interface gigabitethernet 2/0/1
Содержание SR6600 SPE-FWM
Страница 8: ...vi Index 254 ...
