H3C SOHO IE4300, Справочник по командам

Страница: 729 / 3296

4
Usage guidelines
Before enabling a DHCP server to operate as a DHCP relay agent, use the
reset dhcp server
ip-in-use command to clear address bindings and authorized ARP entries. These authorized
ARP entries might conflict with ARP entries that are created after the DHCP relay agent is enabled.
When DHCP server proxy is enabled on the DHCP relay agent, the proxy forwards packets between
the DHCP clients and DHCP server.
•
When receiving DHCP requests from DHCP clients, the proxy forwards them to the DHCP
server.
•
When receiving DHCP responses from the DHCP server, the proxy modifies the DHCP server's
IP address in these responses as its own IP address.
Examples
# Enable the DHCP relay agent on VLAN-interface 2.
<Sysname> system-view
[Sysname] interface vlan-interface 2
[Sysname-Vlan-interface2] dhcp select relay
Related commands
dhcp relay server-address
dhcp relay source-address
dhcp server request-ip-address check
dhcp smart-relay enable
reset dhcp server ip-in-use
DHCP server commands
address range
Use address range to configure an IP address range in a DHCP address pool for dynamic
allocation.
Use undo address range to restore the default.
Syntax
address range start-ip-address end-ip-address
undo address range
Default
No IP address range exists.
Views
DHCP address pool view
Predefined user roles
network-admin
Parameters
start-ip-address
: Specifies the start IP address.
end-ip-address
: Specifies the end IP address.