H3C SOHO IE4300, Справочник по командам

Страница: 506 / 3296

41
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] stp vlan 2 port priority 16
Related commands
display stp
stp port shutdown permanent
Use
stp port shutdown permanent
to disable the device from reactivating edge ports shut
down by BPDU guard.
Use
undo stp port shutdown permanent
to restore the default.
Syntax
stp port shutdown permanent
undo stp port shutdown permanent
Default
The device reactivates an edge port shut down by BPDU guard after the port status detection timer
expires.
Views
System view
Predefined user roles
network-admin
Usage guidelines
This command takes effect only on edge ports shut down by BPDU guard after this command is
configured. The device does not bring up the shutdown ports if you execute the
undo stp port
shutdown permanent
command. To bring up these ports, you must use the
undo shutdown
command.
For more information about the port status detection timer, see device management configuration in
Fundamentals Configuration Guide .
Examples
# Disable the device from reactivating edge ports shut down by BPDU guard.
<Sysname> system-view
[Sysname] stp port shutdown permanent
stp port-log
Use
stp port-log
to enable outputting port state transition information.
Use
undo stp port-log
to disable outputting port state transition information.
Syntax
stp port-log { all | instance instance-list | vlan vlan-id-list }
undo stp port-log { all | instance instance-list | vlan vlan-id-list }
Default
Outputting port state transition information is disabled.