2-12
Figure 2-17 Removing the filler panel from the target power module slot
3.
Unpack the power module. Make sure the power module model is as required.
Keep the packaging box and packaging bag for the power module secure for future use.
4.
Correctly orient the power module. Make sure the lettering on the power module is upward.
5.
Align the power module with the power module slot. Grasping the handle of the power module
with one hand and supporting its bottom with the other, slide the power module slowly into the
slot along the guide rails until the latch of the power module clicks into the slot.
To prevent damage to the power module or the connectors on the backplane, insert the power
module gently. If you encounter a hard resistance when inserting the power module, pull out the
power module and insert it again.
Figure 2-18 Installing a power module
Removing a power module
1.
Wear an ESD wrist strap. Make sure the strap makes good skin contact and is reliably
grounded.
2.
Disconnect the power cord.
3.
Press the latch on the power module towards the handle side, and pull the power module part
way out of the slot along the guide rails.
4.
Grasping the handle of the power module with one hand and supporting module bottom with the
other, pull the power module slowly out of the slot along the guide rails.
5.
Place the removed power module on an anti-static mat or put it into its packaging bag.
