8
Step
Command
Remarks
3.
Enable the RR mode for the
S-channel.
evb reflective-relay
By default, the RR mode is
disabled for an S-channel.
Configuring MAC address learning for an S-channel
You can manually disable the MAC address learning function for an S-channel by performing this task.
To disable MAC address learning for an S-channel:
Step Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Enter S-channel interface
view or S-channel aggregate
interface view.
interface
{
s-channel
|
schannel-aggregation
}
interface-number
:
channel-id
N/A
3.
Disable MAC address
learning for the S-channel.
evb mac-learning forbidden
By default, the MAC address
learning function is enabled for an
S-channel.
IMPORTANT:
•
For an S-channel with the RR
mode disabled, do not disable
its MAC address learning
function. Otherwise, the
bridge might fail to forward
traffic for VMs on the EVB
station.
•
After you disable the MAC
address learning function for
an S-channel, the bridge will
discard packets with an
unknown source MAC
address.
Configuring a VSI interface or VSI aggregate
interface
Creating a VSI interface or VSI aggregate interface
A VSI interface is created on an S-channel interface through this task, and it is a subinterface of the
S-channel interface. A VSI aggregate interface is created on an S-channel aggregate interface, and it is
a subinterface of the S-channel aggregate interface. Removing an S-channel also removes all its VSI
interfaces and VSI aggregate interfaces.
