61
Step
Command
Remarks
2.
Enable local-first load sharing
for link aggregation.
link-aggregation load-sharing
mode
local-first
By default, local-first load sharing
for link aggregation is enabled.
Configuring per-flow load sharing algorithm settings for
Ethernet link aggregation
This feature is available in Release 2311P04 and later versions.
Configure the per-flow load sharing algorithm and algorithm seed to optimize traffic distribution on
aggregate links based on existing per-flow load sharing settings. You can set only the algorithm or the
algorithm seed, or both. You can combine an algorithm with different algorithm seeds to obtain different
effects.
This feature does not take effect on per-flow load sharing that uses the following traffic classification
criteria:
•
Source IP address.
•
Destination IP address.
•
Source MAC address.
•
Destination MAC address.
•
Source and destination IP addresses.
•
Source and destination MAC addresses.
To configure per-flow load sharing algorithm settings for Ethernet link aggregation:
Step Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Configure the load sharing
algorithm.
link-aggregation global
load-sharing algorithm
algorithm-number
By default, algorithm 0 is used.
3.
Configure the load sharing
algorithm seed.
link-aggregation global
load-sharing seed
seed-number
By default, algorithm seed 0 is
used.
Enabling link-aggregation traffic redirection
Link-aggregation traffic redirection prevents traffic interruption.
When you shut down a Selected port in an aggregation group, this feature redirects traffic to other
Selected ports.
When you restart an IRF member device that contains Selected ports, this feature redirects traffic to other
IRF member devices.
Configuration restrictions and guidelines
When you enable ink-aggregation traffic redirection, follow these restrictions and guidelines: