54
Step
Command
Remarks
8.
Configure the port priority for
the interface.
link-aggregation port-priority
port-priority
The default setting is 32768.
9.
Configure the short LACP
timeout interval (3 seconds)
on the interface.
lacp period short
By default, the long LACP timeout
interval (90 seconds) is adopted by
the interface. The peer sends
LACPDUs slowly.
Do not configure the short LACP
timeout interval before performing
an ISSU. Otherwise, traffic
interruption will occur during the
ISSU. For more information about
ISSU, see
Fundamentals
Configuration Guide
.
Configuring an aggregate interface
Most of the configurations that can be performed on Layer 2 or Layer 3 Ethernet interfaces can also be
performed on Layer 2 or Layer 3 aggregate interfaces.
Configuring the description of an aggregate interface
You can configure the description of an aggregate interface for administration purposes such as
describing the purpose of the interface.
To configure the description of an aggregate interface:
Step
Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Enter aggregate
interface view.
•
Enter Layer 2 aggregate interface
view:
interface bridge-aggregation
interface-number
•
Enter Layer 3 aggregate interface
or subinterface view:
interface route-aggregation
{
interface-number
|
interface-number.subnumber
}
N/A
3.
Configure the
description of the
aggregate interface.
description
text
By default, the description of an
interface is in the format of
interface-name
Interface
.