52
Step
Command
Remarks
4.
Assign an interface to the
specified Layer 3 aggregation
group.
a.
Enter Layer 3 Ethernet
interface view:
interface
interface-type
interface-number
b.
Assign the interface to the
specified Layer 3
aggregation group:
port link-aggregation
group
number
Repeat these two sub-steps to
assign more Layer 3 Ethernet
interfaces to the aggregation
group.
Configuring a dynamic aggregation group
To guarantee a successful dynamic aggregation, make sure that the peer ports of the ports aggregated
at one end are also aggregated. The two ends can automatically negotiate the aggregation state of each
member port.
Configuring a Layer 2 dynamic aggregation group
Step
Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Set the system LACP priority.
lacp
system-priority
system-priority
By default, the system LACP priority
is 32768.
Changing the system LACP priority
might affect the aggregation state
of the ports in a dynamic
aggregation group.
3.
Create a Layer 2 aggregate
interface and enter Layer 2
aggregate interface view.
interface bridge-aggregation
interface-number
When you create a Layer 2
aggregate interface, the system
automatically creates a Layer 2
static aggregation group
numbered the same.
4.
Configure the aggregation
group to operate in dynamic
aggregation mode.
link-aggregation mode dynamic
By default, an aggregation group
operates in static aggregation
mode.
5.
Exit to system view.
quit
N/A
6.
Assign an interface to the
specified Layer 2 aggregation
group.
a.
Enter Layer 2 Ethernet
interface view:
interface
interface-type
interface-number
b.
Assign the interface to the
specified Layer 2
aggregation group:
port link-aggregation
group
number
Repeat these two sub-steps to
assign more Layer 2 Ethernet
interfaces to the aggregation
group.
7.
Set LACP to operate in active
mode.
undo lacp mode
By default, LACP is operating in
active mode.
8.
Configure the port priority for
the interface.
link-aggregation port-priority
port-priority
The default setting is 32768.