H3C S5830V2 series, Справочник по командам, Страница: 40 / 301

28
To configure the same settings for multiple user lines, use this command to enter multiple user line
views.
Examples
# Enter the view of user line AUX 0.
<Sysname> system-view
[Sysname] line aux 0
[Sysname-line-aux0]
# Enter the views of user lines VTY 0 to VTY 4.
<Sysname> system-view
[Sysname] line vty 0 4
[Sysname-line-vty0-4]
Related commands
line class
line class
Use line class to enter user line class view.
Syntax
line class { aux | vty }
Views
System view
Predefined user roles
network-admin
Parameters
aux : Specifies the AUX line class view.
vty : Specifies the VTY line class view.
Usage guidelines
To configure the same settings for all user lines of a line class, use this command to enter the user
line class view.
Some login management commands are available in both user line view and user line class view. For
these commands, the device uses the following rules to determine the settings to be activated:
•
A setting in user line view is applied only to the user line. A setting in user line class view is
applied to all user lines of the class.
•
A non-default setting in either view takes precedence over a default setting in the other view. A
non-default setting in user line view takes precedence over a non-default setting in user line
class view.
•
A setting in user line view takes effect immediately and affects the online user. A setting in user
line class view takes effect only for new login users. It does not affect online users.
Examples
# Set the CLI connection idle-timeout timer to 15 minutes in VTY line class view.
<Sysname> system-view
[Sysname] line class vty
[Sysname-line-class-vty] idle-timeout 15